|
Between Patient
Handpiece Maintenance |
|
|
Lubricate Handpiece
Place 2-3 drops of
oil into the intake tube located at the bottom of
the handpiece. Then operate the handpiece, with a
bur installed, for approximately 10 seconds to
expell the oil through and out of the handpiece.
Doing this will flush the debris and contaminations
from the handpiece. Warning: Operating the handpiece
without a bur installed will result in premature
chuck failure. |
| |
Clean Exterior of Handpiece
Wipe down the
exterior of handpiece with alcohol or distilled
water. Remove gross contaminates with a fine wire
brush. Do not use tap water or phosphate based
soaps. |
| |
Sterilize
Individually bag
each handpiece for sterilization. Do not exceed
135C/275F. If using a chemical sterilizer, use clean
chemicals. After cycle allow handpiece to return to
room temperature before use, do not operate that is
hot to touch. Warning: Never leave a handpiece in
the sterilizer overnight. |
| |
Weekly Maintenance
Clean the chuck of
the handpiece once a week. Spray handpiece cleaner
up into the front of the chuck. Removing debris from
the chuck assembly will prolong the life of the
chuck. |
|
Between Patient
Handpiece Maintenance [Lube Free] |
| |
Clean Exterior of Handpiece
Wipe down the
exterior of handpiece with alcohol or distilled
water. Remove gross contaminates with a fine wire
brush. Do not use tap water or phosphate based
soaps. |
| |
Sterilize
Individually bag
each handpiece for sterilization. Do not exceed
135C/275F. If using a chemical sterilizer, use clean
chemicals. After cycle allow handpiece to return to
room temperature before use, do not operate a
handpiece that is hot to touch. Warning: Never leave
a handpiece in the sterilizer overnight. |
| |
Weekly Maintenance
Clean the Chuck of
the handpiece once a week. Spray handpiece cleaner
up into the front of the chuck. Removing debris from
the chuck assembly will prolong the life of the
chuck. |
