O-SO PURE'S-Ultraviolet, Reverse Osmosis Systems
The DWS008 system is designed for 3 different types of applications
 

DWS-POE & DWSPOE-BYPASS

Whole Building (Point-of-Entry) Disinfection System
Disinfect ALL water as it enters the Dental Practice

 

General Information The NEW Self-Cleaning mechanism is the hottest new feature only recently available in water treatment apparatus. Electronic timers easy to program, and continuously rinses the outside area of each filter up to four (4) times per day.   The O-SO PURE (patented) design simply rinses away trapped debris as it accumulates, on a frequent, predetermined basis. This more affordable type 20 inch filter media. Note: When applying the DWSPOE unit for the whole building water application, check plumbing equipment supplied for bathroom stools. If the tankless commercial stools** are used the DWSPOE may not allow the stool to flush properly. Actual filter life is based upon the amount of water used and quality of the water supply. Varying water conditions may affect the life of the filters.   Features Benefits Revolutionary self-cleaning & sub-micron filtration technology & high intensity ultraviolet lamp, destroys waterborne bacteria & viruses. Automatic & programmable timer flushes debris away & prevent premature clogging of filters. Independent Laboratory reports available upon request.       Independent laboratory test analysis confirm the self-cleaning mechanism can and will extend the filter life as much as six (6) times longer. Electronic timer is AC powered with battery backup. Engineered to operate a FULL year before service is required, depending upon water volume & quality. 3 year warranty, US patent #6,984,313,B2 A preferred solution for new offices & is easily installed in existing of offices.

 

Technical Specifications
Housings: 20" Reinforced Polyproplylene		Chlorine Removal: >150,000 Gallons @7 GPM
Min. PSI**: 50 PSI		Dimensions: 31" High-26" Wide-9" Deep
Max PSI: 65 PSI		Shipping Weight: 79 LBS Bypass--82LBS
Max Water Flow: 15 Gal./Min.		UV Lamp Life: 9000 Continuous Hours
Max Temperature: 100°F		UV Lamp Output: 60,000 Microwatt/Cm2
Restrictions: Avoid Direct Sunlight		UV Lamp Watts: 25 Watts
Pipe Size: 1 1/2 Inches		Filter Flush-Flow Rate: 3 Gallons Per Minute
1st Stage Filter	50-Micron Outer Rap & 5-Micron Inner Rap (High Flow Sediment Filter)
2nd Stage Filter	One-Half (1/2) Micron Carbon Block	Recommended Flush Frequencies 4 Per 24 Hours

DWS-POE - Options

General Information

The New DWSMTR-20 ultraviolet system is an upgraded design to provide 8 GPM of bacteria free water to each dental treatment room. This system incorporates three different water technologies into one system. The first stage is a 1 micron sediment filter to remove fine particles like sand, silt, dust and parasites. The second stage filter is a 10 micron carbon block filter that removes chemicals like hydrogen sulfide, chlorine and bad odors. The third stage is the high intensity UV lamp designed to eliminate waterborne bacteria and viruses. Municipal water MUST BE FILTERED FIRST to prevent bacteria and viruses from becoming "SHADED" from the effects of the ultraviolet irradiation.

Actual filter life is based upon the AMOUNT of water used and the QUALITY of the water supply. IT IS RECOMMENDED THAT BOTH FILTERS AND UV LAMP BE REPLACED EVERY 6-12 MONTHS. THE UV LAMP IS RATED FOR 9000 CONTINUOUS HOURS (12 MONTHS) AND SHOULD REMAIN ON AT ALL TIMES TO INSURE PROPER DISINFECTION.

ULTRAVIOLET SYSTEM THAT SUPPLIES 8 GPM

This ultraviolet system produces bacteria free water for each treatment room, (depending on plumbing or separate water loop for treatment rooms). This UV system is a upgraded version of the DWS001 (single operatory system) designed with 20" slim line filters and a vertical ultraviolet lamp to provide enough water for the treatment rooms.

EASY INSTALLATION AND MAINTENANCE

Easily installed wherever it is convenient (not required to be in treatment room), once disinfection protocol has been performed, service is recommended 6 to 12 months (depending upon water use and quality of the water). The system is warranted for 3 years.

Technical Specifications

• Ample water for all your autoclave needs from municipal water.
• Designed to produce low tds water for statim & other autoclaves.
• Up to 160 gallons* (per day) of autoclave quality water.
• This deionization system has been field tested for more than a year, and can be installed independently of the UV disinfection system

The DWS-SADI incorporates three different water treatment technologies into one system: One (1) Dual Purpose Filter (DPF) to reduce dirt and chlorine; Two (2) DI filters to reduce minerals; Reverse Osmosis Membrane to reduce other contaminants from the water providing low Total Dissolved Solid Water (TDS) for Autoclave use.

The input water enters through the DPF filter then through the RO membrane, and from the RO membrane the water goes through the DI filters into the DI Storage Tank before use. The DI water flow from the DI faucet has been reduced to 1000 ML/MIN to allow maximum contact time of the RO water with the DI chemical. The system also comes with a DI monitor that indicates a RED light, signaling the dental staff that the DI filters are exhausted and should be replaced. This DI water is not to be used as DRINKING WATER!

*Based upon the input municipal water of 600 PPM (parts per million) of Total Dissolved solids (TDS) you should expect 160 gallons of low TDS water for your autoclave. If the input of the TDS is lower, expect to receive more autoclave water.

To calculate the amount of parts per million (PPM) removal of the following formula is used: Step 1: Measure the water total dissolved solids (TDS) from the permeate output of the RO Membrane (TDS). Step 2: Given the following formula the estimated amount of DI water available. (31,122/(TDS)

Example if the  measured TDS output from RO Membrane is 30 PPM. The formula is: 31,122/30=1,032 gallons before the DI chemical is exhausted. These calculations also apply to DWS-DDI10
 

Technical Specifications

Standard Features:

• Holds 1 1/2 gallons (6 Liters) of disinfectant liquid.

• Uses a clear filter sump to monitor the amount of liquid disinfectant being poured into sump.

• The liquid disinfectant needs to stand overnight in the waterlines, then flush out with air pressure when cycle is completed.

• Permanent installation for easy use.

• This unit may be used with model DWS-MTR-20

Be sure to start at the farthest hand piece, open it, then repeat for additional hand pieces and allow the disinfectant liquid to flow; then close the hand piece valve or faucet once the liquid appears. After all the hand pieces have been disinfected, let the liquid disinfectant stand overnight in the waterlines, then flush with air pressure when cycle is completed.

An air hose, funnel and a laminated instruction sheet will be provided with every unit. These items should be kept near the Disinfection Purging Unit.

Technical Specifications

DWS008-4-DWSDDI-10

• RO/UV produces 100 Gallons Per Day

• DI flow rate up to 16 Gallons Per Hour

• Eliminate distilled bottle water

• RO & DI water quality monitors

• RO storage tank capacity 3.4 gallons

• Service twice a year

DWS008-10-DWSDDI-10

• RO/UV produces 100 Gallons Per Day

• DI flow rate up to 16 Gallons Per Hour

• Eliminate distilled bottle water

• RO & DI water quality monitors

• RO storage tank capacity 7.6 gallons

• Service twice a year

DWS008-14-DWSDDI-10

• RO/UV produces 100 Gallons Per Day

• DI flow rate up to 16 Gallons Per Hour

• Eliminate distilled bottle water

• RO & DI water quality monitors

• RO storage tank capacity 10.7 gallons

• Service twice a year

All units carry a 3 year warranty